All control groups showed a 100% survival rate. In addition to the phage and bacterial host concentrations, the incubation time was also important

for the P505-15 research buy bactericidal effect. Approximately 95% of phage particles adsorbed to host cells within 5 min, and nearly 100% were adsorbed by 10 min (Figure 1). Therefore, we selected the 5 and 10 min time points to test the bactericidal effect of ϕAB2 in suspension. At a low phage concentration (103 PFU/ml), an increase in the incubation time from 5 to 10 min resulted in a mean decrease of survival rate of MDRAB between 1.5- and 1,700-fold. In contrast, at higher phage concentrations (105 PFU/ml and 108 PFU/ml) there was a mean reduction of bacterial concentration of 1.4- to 7-fold when the incubation time was increased from 5 to 10 min. Figure 3 Bactericidal effect of selleck compound different concentrations: (A) 10 3 (B) 10 5 , and (C) 10 8 PFU/ml of ϕAB2 on different concentrations of A. baumannii M3237 in a liquid suspension, at incubation times of 5 and 10 min. The survival rate was calculated as in the Methods section. learn more These experiments were repeated

three times, and the data shown are the mean ± SEM. *p < 0.05 compared with the respective control group. Bactericidal effect of ϕAB2 on a hard surface The addition of ϕAB2 to a hard glass surface contaminated with A. baumannii M3237 had a bactericidal effect under some conditions (Figure 4). Phage concentrations of 103 and 105 PFU/slide caused a significant reduction (p < 0.05, 40% reduction) of A. baumannii M3237 cells (104 and 105 CFU/slide)

after 10 min (Figure 4A and B). When a phage concentration of 108 PFU/slide was used, the number of A. baumannii Pyruvate dehydrogenase M3237 was significantly reduced (p < 0.05, >90% reduction) after 5 or 10 min for all concentrations of bacteria tested (Figure 4C). However, the bactericidal effect of ϕAB2 at 108 PFU/slide was significantly lower for A. baumannii M3237 at 104 and 105 CFU/slide than at 106 CFU/slide (p < 0.05). To date, there is no standard method for evaluating phage biocontrol efficiency on a hard surface. Incubation times of 5 and 10 min were chosen for surface tests on the basis of ϕAB2 adsorption data (Figure 1) and a previous study by Abuladze et al. [26]. Extending the incubation time from 5 to 10 min increased the mean bactericidal effect on A. baumannii M3237 1.3-fold under all test conditions. Figure 4 Bactericidal effect of different concentrations: (A) 10 3 (B) 10 5 , and (C) 10 8 PFU/slide of ϕAB2 on different concentrations of A. baumannii M3237 on a glass surface following incubation times of 5 and 10 min. The survival rate was calculated as in the Methods section. These experiments were repeated three times, and the data shown are the mean ± SEM. *p < 0.05 compared with respective control group. Use of ϕAB2 as a hand sanitizer in a paraffin oil-based lotion The stability of ϕAB2 in a lotion and its ability to kill A.